Android 4.3 Update for Samsung Galaxy Tab 2 7.0 P3100 (CyanogenMod 10.2 Nightly)

Samsung Galaxy Tab 2

Since the CyanogenMod has released the new update of CM 10.2 Nightly, most of Android users were so happy since this CM 10.2 is Android 4.3 based. This is a custom ROM which allows the users to update their devices to the latest Android 4.3. Samsung Galaxy Tab 2 7.0 P3100 is also one of the supported devices. It hurts to wait for the official update since it will take time. This is a stable custom Android 4.3 ROM which was tested. You might not find serious bugs after updating.

Special Note:

  • This guide and tool only with Samsung Galaxy Tab 2 7.0 P3100 do not attempt to use with other Android device since it can damage the device.
  • Backup everything you want before starting.
  • A custom recovery must be installed on your phone. It can be ClockWorkMod or TWRP but the process is slightly different.
  • Check out your device batter make sure it has more than 40%+ to make sure that it won’t run out.
  • We do not responsible for any loses or damage. Do it at your own risk.

Pre-download section:

How to Update Samsung Galaxy Tab 2 7.0 P3100 to Android 4.3

Step 1: Enable USB debugging option on your device by going to “Setting” > “Applications” > “Development” > check on the box there to enable “USB Debugging”.

Step 2: Now connect your device to PC via USB cable then copy the CM 10.2 Nightly and Google Apps (downloaded above) to SD card.

Step 3: Turn off the phone and boot into Debugging Mode by pressing “Volume Up” and “Power Button” at the same time. Release them when the screen is on and press the Volume Up once the screen prompt the alert.

Step 4: Now on Debugging Mode, you can backup your current ROM so that you can restore it if you don’t like the new one. It is very important and it can be done in just a few minutes.

Step 5: Back to the Debugging Mode, use the up and down volume buttons to wipe all data by selecting “Wipe/Factory Reset” then “Wipe Cache Partition”.

Step 6: Back to Recovery Mode again, select, “flash zip from SD card” and press power button and navigate to where you stored CM 10.2 Nightly in step 2. Now select the zip file then press power button to confirm the installation.

Step 7: Now repeat step 6 to install the Google Apps.

Step 8: It will take a few minute for the installation. After completed, select “+++++Go Back” then reboot system now to reboot your device. This is the first reboot so it might take longer than use about 5 minutes.

Good luck! Now your Samsung Galaxy Tab 2 7.0 P3100 is running on Android 4.3. Enjoy the new features. If you encounter problem, please read the whole steps again.

No comments.

Leave a Reply